Bolster V35, Brass

(No reviews yet) Write a Review
Width:
3.00 (cm)
Height:
0.30 (cm)
Depth:
1.90 (cm)
Gift wrapping:
Options available
Shipping:
Calculated at Checkout
  • Bolster V35, Brass
$5.04

Description

Bolster V35, Brass (35 x 17 x 3 mm, slit 3 x 19 mm V shaped)

Brass version of the bolster V35 with a V slit thinner in one end.

Bolsters is an easy way to get a good looking fit between handle and blade.

The handle piece can then have a bigger hole for the blade tang without this being visible.

The slit in the bolster is about 3 x 19 mm and the bolster is 3 mm thick.

These are stamped out and most blade/bolster combinations will need some work to fit together.

Filing the sides of the blade tang using a hand file or dremel is a good way to get a tigth fit.

Often the face of the bolster is sanded flat on a piece of glass or tile, then sanded to the wanted finish before being attached to the blade.

This is a lot easier than trying to sand it with the blade in.

Please note on page for the blade you are looking at, what the right bolster is.

 http://creativeman.com.au/knife-kits/

View AllClose