Corby Bolt 1/4", Stainless Steel

Corby Bolt, Stainless Steel (1/4", 6.5 mm)

Medium size corby bolt in steel, for securing handle scales to full-tang knife blades.

These are often used in addition to epoxy glue, for both looks and additional attachment strength of the handle scales.

The bolt has thicker end pieces (6.5 mm / 1/4") with screwdriver slots in them, total length is 28 mm.

The centre section is 4.69 mm thick and is the part that goes through the blade.

The bolt is threaded, consisting of two pieces that when tighetend is ground down to sit flush with the handle scales.

This is for a single bolt, if ordering a knife kit you will receive 2 or 3 bolts depending on the blade for the same cost of $5.

 Example of corby bolts in Danish made Raffir "Grand Chef" blade, knife by Åge Fjeldberg: