null

Corby Bolts, Stainless Steel (20 bolts)

(3 reviews) Write a Review
Width:
5.00 (cm)
Height:
5.00 (cm)
Depth:
10.00 (cm)
Gift wrapping:
Options available
Shipping:
Calculated at Checkout
  • Corby Bolts, Stainless Steel (20 bolts)
  • Corby Bolts, Stainless Steel (20 bolts)
  • Corby Bolts, Stainless Steel (20 bolts)
  • Corby Bolts, Stainless Steel (20 bolts)
$40.00

Description

20 x Corby Bolts, Stainless Steel (1/4", 6.5 mm)

Medium size corby bolt in steel, for securing handle scales to full-tang knife blades.

These are often used in addition to epoxy glue, for both looks and additional attachment strength of the handle scales.

The bolt has thicker end pieces (6.5 mm / 1/4") with screwdriver slots in them, total length is 28 mm.

The centre section is 4.69 mm thick and is the part that goes through the blade.

The bolt is threaded, consisting of two pieces that when tighetend is ground down to sit flush with the handle scales.

 

This is for a set of 20 bolts.

 

 Example of brass corby bolts in Danish made Raffir "Grand Chef" blade, knife by Åge Fjeldberg:

corbyboltsraffirfjeldbergexample.jpg

View AllClose

3 Reviews

  • 4
    S/Steel Corby Bolts

    Posted by Nick on 21st Jul 2020

    Service and delivery is excellent, bolts are great

  • 4
    Corby bolts

    Posted by Leo on 27th May 2020

    Quite nice quality machining, although the shaft below the thread could be left a bit thicker - this is where I have had many smaller Corby’s snap when tightening them up snug. Haven’t applied them to a handle yet so we’ll see how they go.

  • 5
    Corby Bolts

    Posted by Ronald Tufnell on 8th Jul 2019

    Corby bolts from Bjorn ( Creative Man ) are really top quality.
    They look like they are made on a CNC Machine and the sizes are highly accuracy.
    They are one of the strongest fasteners for handles.
    Probably the biggest advantage of Corby bolts is that they eliminate the need for clamps. You put the epoxy on the tang, and a little bit in the holes through the scales, insert the Corby parts and assemble the handle. Tighten only snug, wipe off excess epoxy, check the sides for gaps and alignment, tighten/adjust a tad more if needed ( Do Not Over torque) and set it aside to cure.

View AllClose