Damascus FIREBALL Pattern Billet, Stainless Steel 58 HRC, 250 x 35 x 4 mm

(1 review) Write a Review
0.40 (cm)
3.50 (cm)
25.00 (cm)
Gift wrapping:
Options available
Calculated at Checkout
  • Damascus FIREBALL Pattern Billet, Stainless Steel 58 HRC, 250 x 35 x 4 mm


Stainless Steel Damascus Billet,  4 x 35 x 250 mm (FIREBALL PATTERN)

Hardened and Tempered to 56-58 HRC cutting steel SAN MAI'ed with soft damascus steel.

Damascus or "forge welded" steel consists of different types of steel heated to welding temperatures and mashed together until they form one steel. The billet is then drawn out, cut or folded. The process is repeated again and again, every time doubling the number of layers.

To get a consistent, strong edge these pieces consist of softer stainless layers over a hard single steel centre edge piece. Basically forge welding the damascus to a Chinese version of VG10.

The billet is ready to grind into a blade and is slightly bigger than 4 mm x 35 mm x 250 mm in size.

The Damascus billet is heat treated completely, hardened and tempered to 56-58 HRC. This is a good hardness for outdoor knives as well as general duty kitchen knives.

This is the Fireball pattern version and comes flat ground and pre-etched so the pattern is clearly visible already.

(some of the photos show the billets before they are ground flat and etched)

Note this is hardened steel and will be very difficult to work with hand tools.

  • Grind the billet to your blade design keeping it cool to not ruin the temper
  • Grind in bevels
  • Hand sand the blade
  • Etch in ferric chloride or etchant solution from an electronics store
  • Wash thoroughly with water to neutralise the acid


NOTE: Working with acids can be dangerous. Seek professional advice before undertaking any work that can involve risk of injury.




View AllClose

1 Review

  • 5
    Haven’t used yet

    Posted by Mark Robertson on 4th Aug 2020

    Will let u know

View AllClose